Crankshaft test values |
Number | Designation | Engine 612.983 in type 979 | |||
BE03.20-B-1001-02F | Diameter of the main neck | Normal | mm | 57,940...57,965 | |
Repair I | mm | 57,700...57,715 | |||
repair II | mm | 57,450...57,465 | |||
repair III | mm | 57,200...57,215 | |||
repair IV | mm | 56,950...56,965 | |||
BE03.20-B-1002-02F | Width | of the main adjustment neck | Normal | mm | 24,500...24,533 |
Normal I | mm | 24,600...24,633 | |||
Repair I | mm | 24,700...24,733 | |||
repair II | mm | 24,900...24,933 | |||
repair III | mm | 25,000...25,033 | |||
of the other main necks | mm | 23,900...24,100 | |||
BE03.20-B-1003-02F | Connecting rod neck diameter in the crankshaft | Normal | mm | 47,940...47,965 | |
Repair I | mm | 47,700...47,715 | |||
repair II | mm | 47,450...47,465 | |||
repair III | mm | 47,200...47,215 | |||
repair IV | mm | 46,950...46,964 | |||
BE03.20-B-1004-02F | Crankshaft axial play | new | mm | 0,10...0,25 | |
wear limit | mm | 0,3 | |||
BE03.20-B-1005-02F | Radial play in the main necks | new | mm | 0,03...0,05 | |
wear limit | mm | 0,08 | |||
BE03.20-B-1006-02F | Hardness of the main necks and the connecting rods' necks (Rockwell hardness) | minimum | HRC | 53...59 | |
BE03.20-B-1007-02F | Main bearing thickness (sleeves housing) | mm | 62,500...62,519 | ||
BE03.20-B-1008-02F | Thickness of top and bottom compensation washers | Normal | mm | 2,15...2,20 | |
Normal I | mm | 2,20...2,25 | |||
Repair I | mm | 2,25...2,30 | |||
repair II | mm | 2,35...2,40 | |||
repair III | mm | 2,40...2,45 | |||
BE03.20-B-1009-02F | Maximum crankshaft run-out (crankshaft mounted on end journals) | mm | 0,16 | ||
BE03.20-B-1010-02F | Connecting rod neck width | mm | 27,9...28,1 | ||
BE03.20-B-1011-02F | Necks matching radius | main | mm | 1,9...2,1 | |
connecting rods | mm | 1,9...2,1 | |||
BE03.20-B-1012-02F | Bulging on the primary and connecting rod necks | mm | 0...0,004 | ||
BE03.20-B-1013-02F | Maximum roundness and taper in the main and connecting rod necks | new or machined crankshaft | mm | 0,01 | |
BE03.20-B-1014-02F | Maximum roughness on the polished necks | (Rt) | mm | 0,0015 | |
BE03.20-B-1015-02F | Maximum dynamic unbalancing. | at 500/min. | Ncm | 0,1 |