When a FleetBoard® control unit is retrofitted, the telematics must be enabled with the diagnostic system. To this end, the menu specified items in the chronologically listed systems must be selected and the changes that are described must be carried out.
1 | Connect diagnostic system. |
2 | Start "XENTRY". |
3 | Select brand selection "Mercedes-Benz". |
4 | Select category selection "Truck". |
5 | Select "Automatic model series access". |
6 | Select "Diagnosis application". |
7 | Select system recognition. |
8 | Select menu item "Control unit direct entry". |
9 | Select instrument (INS). |
Menu item "Control unit adaptations"
"Parameterization" menu item
Menu item "Control unit list (IES-CAN bus control units)"
Menu item "TP telematics platform"
Set "TP telematics platform" to "PRESENT" and confirm with "F3" key
10 | Select parameterizable special module (PSM). |
Menu item "Control unit adaptations"
"Parameterization" menu item
Menu item "General parameter set"
Menu item "900/Telematics service"
Menu item "All parameters"
Menu item "900.530/Communications interface (KOM)"
Set "Communications interface (KOM)" to "ACTIVE" and confirm with "F3" key
Return to menu item "General parameter set" by repeatedly pressing the "F1" key
Menu item "General parameter set"
Menu item "910/Vehicle equipment"
Menu item "All parameters"
Menu item "910.500/gear ratio in highest gear"
Check gear ratio in highest gear, adjust if necessary and confirm with "F3" key
11 | Select maintenance system (WS). |
Menu item "Control unit adaptations"
"Parameterization" menu item
Menu item "Fuel consumption"
Menu item "Fuel consumption measurement"
Set "Fuel consumption measurement" to "ACTIVE" (not to telematics) and confirm with "F3" key
12 | End procedure and remove diagnostic system. |