ar9720s4000s

Install transport foil

Type ar · emne 97.20 · version 0105 · 2019-12-09

Gælder for: Model 636, 639

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 3 Karrosseri › 97 Karrosseritætning, korrosionsbeskyttelse › 97.20 Konservering — Serie 636 · Serie 639

EinPAS 40 Konservering/lakering › 40.15 Lakering/lakpleje › 40.15.30 lakpleje/krompleje/folier/transportbeskyttelse — Serie 636 · Serie 639

AR97.20-S-4000S

Install transport foil

06.12.2019

Model

636, 639

Danger

Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)

Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.

AS00.00-Z-0035-01A

Topical note

General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system

AH00.00-Z-0300-01A

Notes on transportation sheeting

AH97.20-P-9409-03A

1

Remove old foils

If installed.


Heat surfaces to be machined
but not so much that they can no longer be touched. Increased temperature can cause paint damage.

Removal can be facilitated by heating.

2

Clean vehicle

Buff wet vehicles until they are dry.

3

Check surface of vehicle

Visible edges of the tape can remain (when performing a reapplication). These edges are removed during paintwork preparation at the sales centers (VPC) or dealerships.

Minor swelling during reapplication is insignificant. The new foil can be applied to these painted surfaces.

4

Apply new transportation foil


Do not mask plastic parts and rubber profiles with foil.
Otherwise glue residues may be present.

The new transport foil is applied manually.

Henviste dokumenter