ar9160p0950lwe

Remove/install crash sensor

Type ar · emne 91.60 · version 0103 · 2019-11-11

Gælder for: Model 213, 238 with code U60 (Pedestrian protection - Active hood)

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 3 Karrosseri › 91 Sæder, køjer, selestrammere › 91.60 Airbag, fodgængerbeskyttelse — Serie 213 · Serie 238

EinPAS 27 Passive sikkerhedssystemer › 27.35 Fodgængerbeskyttelse › 27.35.12 Sensor/kontakt/ledningssæt — Serie 213 · Serie 238

AR91.60-P-0950LWE

Remove/install crash sensor

05.11.2019

Model

213, 238

with code U60 (Pedestrian protection - Active hood)

Remove/install crash sensor

P91.60-4993-08

Shown on model 213

1

Front bumper

3

Impact absorber

4

Pedestrian protection sensor

2

Hose

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Topical note

General information on the impact absorber

AH88.20-P-1000-01A

Topical note

Notes on pedestrian protection sensor

AH91.60-P-0001-01A

Remove/install

1

Remove front bumper (1)

AR88.20-P-2000LWE

2

Disconnect electrical connector at left and right pedestrian protection sensor (4)

3

Remove hose (2) from groove in impact absorber (3)

Installation:
Ensure that hose (2) is seated correctly in impact absorber (3). The hose (2) must be routed without any tension or kinks.
Otherwise the pedestrian protection system may malfunction.

Installation: Position hose (2) as deep as possible in groove of impact absorber (3).
Hose (2) must protrude the same amount at the impact absorber (3) along the entire length.

4

Remove left and right pedestrian protection sensor (4) together with hose (2)


Pedestrian protection sensors (4) are permanently connected to hose (2) and must not be separated.
Otherwise the pedestrian protection system may malfunction.

5

Install in the reverse order

Henviste dokumenter