AR91.18-P-1870P | Remove and install rear seat backrest upholstery | 25.6.07 |
MODEL 203.0
MODEL 209.3 except CODE (P98) Black Series
P91.12-2213-11
Shown with code 287 Through-loading feature
1 Backrest side cover
2 Bracket
3 Bolts
4 Cover plate for through-loading opening
5 Back side trim frame around through-loading opening
6 Ski bag
7 Cover
8 Pneumatic line
9 Upholstery
10 Cover
P91.18-2080-01
P91.18-2081-01
P91.18-2082-01
Shown with code 287 Through-loading feature
9 Upholstery
11 Head restraint guides
23 Upholstery wires
24 Foam padding
12 Rear seat backrest
13 Rear armrest
14 Interior through-loading trim
22 Clips
| Remove/install | ||
1 | Remove rear heat restraints | ||
2 | Remove rear seat backrest (12) | Model 203 with code 287 Through-loading feature | |
Model 203 without code 287 Through-loading feature | |||
Model 209 | |||
3 | Set rear seat backrest (12) down on a suitable surface | ||
4.1 | Remove ski bag (6) | With code 282 Ski bag | |
4.2 | Unscrew screws (3) and remove rear panel through-loading cover (4) and rear panel through-loading trim (5) | With code 287 Through-loading feature | |
5 | Remove backrest side cover (1) | ||
6 | Dislodge the upholstery (9) from the attachment groove running around the rear backrest frame | ||
7 | Turn the screw out of the vehicle center bracket (2) | ||
8 | Remove the interior side trim frame (14) | With code 287 Through-loading feature | |
9 | Unscrew bolts from rear armrest (13) | ||
10 | Remove rear armrest (13) | ||
11 | Unhook upholstery (9) from attachment groove running around rear backrest frame (13) | ||
12 | Release seat belt cover (10) | Model 203.0 | |
13 | Take off cover (7) | ||
14 | Remove head restraint guides (11) | ||
15 | Unhook upholstery wire from rear seat backrest frame | ||
16 | Carefully pull out the safety belt | Model 203.0 | |
17 | Remove upholstery (9) together with foam padding (24) | ||
18 | Push upholstery (9) over foam rubber layer (24) | ||
19 | Release (22) longitudinal and lateral upholstery clips | To do this, rotate clips (22) through 90°. | |
Installation: Align clips (22) and connect to the upholstery wires (23). | |||
20 | Pull the upholstery wires (23) out of the fabric sleeves | Installation: Pull in upholstery wires (23) and align. | |
21 | Install in the reverse order |