Remove/install rear seat cushion

AR91.12-P-1020LF

Remove/install rear seat cushion

02.10.2019

Model

217

Model

222.0/1/9

except code 223 (Electric backrest adjustment and head restraints)

except code 224 (Rear individual seat design)

Shown on MODEL 222

1

Seat cushion

5

Electrical connector

2

Wire hoop

5.1

Connector

3

Pilot bushing

5.2

Retaining clip

4

Seat backrest

6

Damping material

Shown on left side of vehicle on model 222

1

Seat cushion

2

Wire hoop

2.1

Security catch

7

Wire hoop

8

Safety hook

 

Remove/install

1

Move both front seats forwards

2

Pull seat cushion (1) upwards out of pilot bushings (3)


Lock tabs (2.1) must not be bent.
Otherwise the lock tabs (2.1) cannot engage correctly in the pilot bushings (3).

 Reach under the seat cushion (1) (arrow) by hand and press the lock tab (2.1) back to the end stop.

 Installation: Ensure that wire hoops (2) are seated correctly in pilot bushings (3).

3

Push seat cushion (1) towards rear and unhook from both safety hooks (8)

Model 222.0/1
except code 223 (Electric backrest adjustment and head restraints)
except code 224 (Rear individual seat design)

 Installation: Ensure that safety hooks (8) are seated correctly in wire hoops (7) of seat cushion (1).

4

Fold over soundproofing (6) to disconnect electrical connector (5)

5

Unclip, release and disconnect electrical connectors (5) at left and right

Model 217
with code 872 (Left and right rear seat heating)
Model 222.0/1
with code 872 (Left and right rear seat heating)
except code 223 (Electric backrest adjustment and head restraints)
except code 224 (Rear individual seat design)

 Installation: Ensure that electrical connectors (5) are seated correctly in respective retaining clip (5.2).
Note routing of electrical wiring harness of electrical connector (5) below backrest (4).

6

Remove seat cushion (1) from vehicle


Carefully remove seat cushion (1) from vehicle.
Otherwise vehicle components may be damaged.

7

Install in the reverse order