P88.80-2269-09
Shown on left side of vehicle on model 213.0 |
1 | Longitudinal member panel | 4 | Mounting clip | |
2 | Front to liner | 5 | Rear fender liner | |
3 | Expansion rivet | 7 | Underfloor paneling |
P88.80-2268-09
Shown on left side of vehicle on model 213.0 |
1 | Longitudinal member panel | 11 | Extraction hook | |
8 | Mounting clip | 12 | Retaining clips | |
9 | Fender | 13 | Mounting clip | |
10 | Mounting clip |
| Remove/install | ||
1 | Detach underfloor paneling (7) in area of longitudinal member paneling (1) and pull downward over mounting bolts | ||
2 | Remove expansion rivets (3) | ||
3 | Turn retaining clips (4) 90° and remove | ||
4 | Open front door | ||
5 | Open rear door | ||
6 | Mask rear door in front bottom area with felt strips | Scratches to the longitudinal member paneling (1) through the rear door can be prevented by felt strips. | |
Felt strip | |||
7 | Press front fender liner (2) to side until retaining clip (8) below is accessible | ||
8 | Unclip retaining clip (8) from fender (9) with suitable pliers | ||
9 | Unclip longitudinal member paneling (1) starting at rear upward from retaining clips (10, 12 and 13) with extraction hook (11) | Extraction hook | |
10 | Remove longitudinal member panel (1) | ||
11 | Remove retaining clip (8, 13) from longitudinal member paneling (1) and clip into fender (9) | Installation: Replace damaged retaining clips (8, 13). | |
12 | Remove retaining clips (10, 12) remaining on vehicle and install on longitudinal member panel (1) | Turn retaining clip (10) 90° with suitable pliers and remove. | |
Installation: Remove damaged retaining clips (10, 12). | |||
13 | Install in the reverse order |
140 589 02 33 00
Extraction hook