P88.80-2241-09
Shown on model 205.0 |
1 | Longitudinal member panel | 5 | Rear fender liner | |
2 | Front to liner | 6 | Quick-release coupling | |
3 | Expansion rivet | 7 | Underfloor paneling | |
4 | Mounting clip |
Model 205.0/1/2 |
1 | Longitudinal member panel |
14 | Rear door |
15 | Felt |
P88.80-2243-04
P88.80-2242-09
Shown on model 205.0 |
1 | Longitudinal member panel | 11 | Extraction hook | |
8 | Mounting clip | 12 | Retaining clips | |
9 | Fender | 13 | Mounting clip | |
10 | Mounting clip |
| Remove | ||
1 | Detach underfloor paneling (7) in area of longitudinal member paneling (1) and pull downward over mounting bolts | ||
2 | Remove rear expansion rivet (3) | ||
3 | Unscrew quick-release coupling (6) | Model 205.0/1/2 | |
4 | Remove front expansion rivet (3) | ||
5 | Turn retaining clips (4) 90° and remove | ||
6 | Open front door | ||
7 | Open rear door | Model 205.0/1/2 | |
8 | Mask rear door (14) in lower rear of felt (15) | Model 205.0/1/2 | |
Felt strip | |||
9 | Press front fender liner (2) to side until retaining clip (8) below is accessible | ||
10 | Unclip retaining clip (8) from fender (9) with suitable pliers | ||
11 | Unclip longitudinal member paneling (1) starting at rear upward from retaining clips (10, 12 and 13) with extraction hook (11) | Extraction hook | |
12 | Remove longitudinal member panel (1) | ||
| Install | ||
13 | Remove retaining clip (8) from longitudinal member paneling (1) and clip into fender (9) | Retaining clip (13) remains on fender. | |
Replace damaged retaining clips (8, 13). | |||
14 | Remove retaining clips (12) remaining on vehicle and install on longitudinal member panel (1) | Replace damaged retaining clip (12). | |
15 | Remove retaining clips (10) remaining on vehicle and install on longitudinal member panel (1) | Model 205.0/1/2 | |
Replace damaged retaining clip (10). | |||
Turn retaining clip (10) 90° with suitable pliers and remove. | |||
16 | Clip longitudinal member panel (1) starting at rear into retaining clips (10, 12 and 13) | ||
17 | Push front fender liner (2) to side and install retaining clips (8) below on fender (9) | ||
18 | Install retaining clips (4) | ||
19 | Install front expansion rivets (3) | ||
20 | Press quick-release coupling (6) to end stop | Model 205.0/1/2 | |
21 | Fasten underfloor paneling (7) in area of longitudinal member panel (1) | ||
22 | Remove felt (15) in lower rear of rear door (14) | Model 205.0/1/2 |
140 589 02 33 00
Extraction hook