Remove/install trunk lid handle

AR88.50-P-5062EW

Remove/install trunk lid handle

10.9.13

MODEL

207, 212.0/1

Illustrated on model 207.3

1

Trunk lid

2

Trunk lid paneling

3

Screw

4

Cover

5

Clip

6

Clips

E40

Trunk lid ambient lamp

Shown on model 212.0 remove removed trunk lid paneling

7

Electrical connector

9

Clips

11

Adhesive pad

8

Bow

10

Trunk lid grab rail

12

Catch hook

 

Remove/install

 Danger !

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A



Notes on sensor system for trunk lid opening/closing

AH80.61-P-0001-01A

1

Remove screws (3) at cover (4)

MODEL 207

2

Unclip clips (5)

 Clip remover

*452589016300

3

Loosen cover (4) until electrical connector on trunk lid ambient lamp (E40) is accessible

4

Disconnect electrical connector from trunk lid ambient lamp (E40) and remove cover (4)

5

Remove clips (6) from trunk lid panel (2)

6

Guide trunk lid paneling (2) out of trunk lid (1) and pivot downward

 Hazard warning triangle remains in bracket.

7

Disconnect electrical connector (7)

8

Pull bow (8) toward rear (arrows) and remove

9

Unclip catch hook (12)

MODEL 212.0/1

10

Unclip clips (9)

 Installation: Check clips (9) for damage, replace if necessary.

11

Pull trunk lid handle (10) out of extraction hook and remove

 Installation: Replace adhesive pad (11) on trunk lid handle strip (10).

 Extraction hook

*140589023300

12

Install in the reverse order