Shown on MODEL 222 |
1 | Handle strip |
2 | Trunk lid |
P88.50-3115-06
1 | Handle strip |
3 | Retaining clip |
4 | Adhesive pad |
5 | Bow |
6 | Electrical connector |
P88.50-3160-06
Danger ! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove/install | ||
1.1 | Remove paneling from trunk lid (2) | MODEL 218.3 | |
1.2 | Remove rear-end door wiper motor | MODEL 218.9 | |
2 | Pull bracket (5) toward rear (arrow) and remove | ||
3 | Disconnect electrical connector (6) | ||
4 | Remove license plate or license plate with license plate bracket | ||
5 | Mask crosshatched area (C) on trunk lid (2) or rear door as shown | ||
6 | Pull out handle strip (1) with extraction hook (arrow A) | Extraction hook | |
7 | Unclip handle strip (1) from trim piece with assembly wedge (arrows B) | Mounting wedge | |
8 | Unclip retaining clips (3) and remove handle strip (1) | Installation: Check retaining clips (3) for damage, replace if necessary. | |
Mounting wedge | |||
9 | Remove adhesive residues from trunk lid (2) or rear door and clean bonding surface | Bonding surface must be free of grease and dust. | |
Observe flash-off time for cleaning agent. | |||
Cleaner | |||
10 | Remove adhesive residues from handle strip (1) and install new adhesive pad (4) on handle strip (1) | When reusing handle strip (1). | |
Bonding surface must be free of grease and dust. | |||
Observe flash-off time for cleaning agent. | |||
Cleaner | |||
11 | Install in the reverse order |
110 589 03 59 00
Mounting wedge
140 589 02 33 00
Extraction hook
Henviste dokumenter
- ar8230p6900cx Af-, påmontering af viskermotor bagklap
- as0000z001101a Fare for personskade pga. fastklemning eller knusning af fingre ved af-, påmontering og indstillingsarbejde på motorhjelm og bagklap, døre, dæksler og soltag.