ar8820s2200s

Remove/install rear bumper

Type ar · emne 88.20 · version 0302 · 2019-12-23

Gælder for: Model 636, 639

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 3 Karrosseri › 88 Monteringsdele, udvendige klapper › 88.20 Kofangere — Serie 636 · Serie 639

EinPAS 35 Karrosseri/ramme/monteringsdele › 35.38 kofanger/spoiler/beklædning udvendig/opbevaringsboks/frontbeskyttelse › 35.38.31 Kofanger bagest — Serie 636 · Serie 639

AR88.20-S-2200S

Remove/install rear bumper

06.12.2019

Model

636, 639

Remove/install rear bumper

N88.20-2068-09

Shown with code W65 (Liftgate)

1

Clip

4

Bolts

2

Bumper

5

Nuts

3

Clip

X35/28

PARKTRONIC connector, rear bumper (with code EZ8 (PARKTRONIC))

Remove/install rear bumper

Shown with code ZE0 (special model X-CLUSIVE)

6

Screw

7

Sleeve

S88.20-4513-11

Remove/install

Danger

Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)

Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.

AS00.00-Z-0035-01A

Topical note

General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system

AH00.00-Z-0300-01A

1.1

Remove the retaining clips (1) on the wheel arches

Model 636
Model 639
except code ZE0 (Special edition X-CLUSIVE)

1.2

Remove screw/bolt (6)

Model 639
with code ZE0 (Special edition X-CLUSIVE)

Topical note

Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

Installation: Ensure that the sleeve (7) is seated correctly.

2

Release the corners of the bumper (2) and pull out (arrow)

3

Remove the retaining clip (3) on the center section of the bumper (2)

Check the condition of the retaining clip (3); replace if necessary.

4

Remove screws (4)

Screw/bolt for rear bumper

*BA88.20-N-1003-01E

5

Remove the rear-end doors from the brackets and open all the way to the end stop

Vehicles except code W65 (tailgate)

6

Pull the bumper (2) on the left side of the vehicle back slightly

Vehicles with code EZ8 (PARKTRONIC)

7

Unscrew nuts (5).

Vehicles with code EZ8 (PARKTRONIC), except code XZ1 (model generation 1)

8

Disconnect the PARKTRONIC connector, rear bumper (X35/28)

Vehicles with code EZ8 (PARKTRONIC)

9

Release the plug on the holder and push out

Model 639
with code XZ1 (Model generation 1)

10

Remove bumper (2)

Use aid of helper.

11

Install in the reverse order

Check

12

Check the PARKTRONIC sensors to ensure that they are functioning properly

Vehicles with code EZ8 (PARKTRONIC)

Bumper

Number

Designation

Model 636, 639

BA88.20-N-1003-01E

Screw/bolt for rear bumper

Nm

9

Henviste dokumenter