ar8210s4731p

Remove/install rear lamp unit

Type ar · emne 82.10 · version 0100 · 2017-08-10

Gælder for: Model 470, 471

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 3 Karrosseri › 82 El-system, karrosseri › 82.10 Udvendig belysning — Serie 470 · Serie 471

EinPAS 30 Belysningsanlæg › 30.15 Udvendig belysning › 30.15.41 Baglygte — Serie 470 · Serie 471

AR82.10-S-4731P

Remove/install rear lamp unit

26.07.2017

Model

470, 471

Remove/install rear lamp unit

Shown on left side of vehicle

1

Mounting clip

2

Nut

3

Electrical connector

E3

Left rear lamp unit

E4

Right rear lamp unit

S82.10-4679-06

Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Remove/install

1

Switch off exterior lighting and turn signal lights

2

Switch off ignition and store transmitter key outside of transmission range (min. 2 m)

3

Remove retaining clip (1)

Clip remover

*452589016300

4

Unscrew nuts (2)

5

Take lamp unit (E3, E4) out of dropside far enough to access electrical connector (3)


Handle lamp unit (E3, E4) with care.
Otherwise damage may occur to the vehicle paint and/or to the lamp unit (E3, E4).

6

Disconnect electrical connector (3) and remove lamp unit (E3, E4)

7

Install in the reverse order

Check

8

Perform function check of lamp units (E3, E4)

AP82.10-S-8251P

Remove/install rear lamp unit

452 589 01 63 00

Clip remover

Henviste dokumenter