D82.10-1221-07
Shown on model 907 |
1 | Level sensor | 4 | Linkage rod | 7 | Electrical connector | ||
2 | Screw | 5 | Screw | ||||
3 | Nut | 6 | Bracket |
D82.10-1222-07
Shown on model 910 |
1 | Level sensor | 4 | Linkage rod | 7 | Electrical connector | ||
2 | Screw | 5 | Bolts | ||||
3 | Nut | 6 | Bracket |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Perform commissioning of headlamp control unit with vehicle diagnosis system. | If the level sensor (1) is replaced. | |
| |||
2 | Raise vehicle. | ||
Topical note | Special instructions for lifting and supporting vehicle | ||
3 | Remove lower engine compartment paneling. | If installed. | |
4 | Counterhold screw (2), unscrew nut (3) and remove linkage (4) from level sensor (1). | ||
Topical note | Notes on self-locking nuts and bolts | ||
Bolt/nut, linkage to level sensor | |||
5 | Remove screws (5) and remove level sensor (1) from holder (6). | Bolt, level sensor to bracket | |
6 | Disconnect electrical connector (7) and remove level sensor (1). | ||
7 | Install in the reverse order. | ||
| Check | ||
8 | Check and correct headlamp adjustment. | If the level sensor (1) was replaced. | |
Henviste dokumenter
- ad0000d200006ts
- ah0000n000101a Oplysninger om selvlåsende bolte og møtrikker
- ah0060n010001ts Bemærkning til hævning og opklodsning
- ah5400p000101a Oplysninger med henblik på at undgå skader på elektroniske komponenter på grund af elektrostatisk afladning
- ar0060d100004ts
- ar6120d1105ts
- ar8210d1131ts