Remove/install rear axle level sensor

AR82.10-D-0005TS

Remove/install rear axle level sensor

13.12.2017

Model

907, 910

with code LG7 (LED high-performance headlamps)

Shown on model 907

1

Level sensor

2

Nut

3

Screw

4

Electrical connector

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

 

Remove/install

1

Perform commissioning of headlamp control unit using vehicle diagnosis system

When replacing level sensor (1).



AD00.00-D-2000-06TS

 Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

2

Raise vehicle

AR00.60-D-1000-04TS

Topical note

Special instructions for lifting and supporting vehicle

AH00.60-N-0100-01TS

3

Unscrew nut (2), remove relevant bolt disassemble linkage from level sensor (1)

Topical note

Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

 Bolt/nut, linkage to level sensor

*BA82.10-N-1001-02TS

4

Remove bolts (3) and remove level sensor (1) from holder

 Bolt, level sensor to bracket

*BA82.10-N-1002-02TS

5

Disconnect electrical connector (4) and remove level sensor (1)

6

Install in the reverse order



Check

7

Check/correct position of headlamps

After replacing level sensor (1).

AR82.10-D-1131TS

 Rear axle level sensor

Number

Designation

Model 907, 910
with code LG7 (LED high-performance headlamps)

BA82.10-N-1001-02TS

Bolt/nut, linkage to level sensor

Nm

8

 Rear axle level sensor

Number

Designation

Model 907, 910
with code LG7 (LED high-performance headlamps)

BA82.10-N-1002-02TS

Bolt, level sensor to bracket

Nm

5