AR77.20-W-1000E | Remove/install tilting/sliding roof panel | 27.5.10 |
BODY 375.840
with CODE (D27) Steel power tilting/sliding roof
except CODE (DD5) Cab with high roof
BODY 942.899
with CODE (D27) Steel power tilting/sliding roof
with CODE (D45) Glass power tilting/sliding roof
BODY 944.899
with CODE (D27) Steel power tilting/sliding roof
except CODE (DD5) Cab with high roof
W77.20-0007-06
Shown on electric, glass tilting/sliding roof
1 Eccentric disk
2 Slide rail
3 Pin
4 Tilting/sliding roof panel
5 Pin
6 Slide rail
7 Screw
A Pivot direction
| Remove/install | ||
1.1 | Move electric tilting/sliding roof to service position | After opening tilting/sliding roof press "Tilting/sliding roof" switch again and hold down. After approx. 6 s the tilting/sliding roof is moved to service position. | |
1.2 | Set mechanical tilting/sliding roof to service position | When electric actuation does not function. Insert Allen wrench (vehicle tool kit) into tilting/sliding roof motor Press Alan wrench upward and turn until tilting/sliding roof is completely open. | |
2 | Remove bolts (7) | | |
3 | Slide tilting/sliding roof (4) toward rear and fold up | Installation: Ensure that the slide rails (2) are pushed over the bolts (3) | |
4 | Remove bolts (5) from slide rails (6) and remove tilting/sliding roof panel (4) | Installation: Pivot eccentric disk (1) to stop in pivot direction (A) | |
5 | Install in the reverse order |
Electric sliding roof