Remove, install license plate lamp bracket

AR72.20-S-1010S

Remove, install license plate lamp bracket

06.12.2019

Model

636, 639

Shown on model 639 up to vehicle identification number (VIN) 094908 without CODE W65 (Liftgate) and without CODE FR8 (Backup assist (rearview camera))

1

Nut

2

License plate lamp bracket

Shown on model 639 up to VIN 094908 without CODE W65 (Liftgate) and without CODE FR8 (Backup assist (rearview camera))

1

Nut

3

Electrical connector

Shown on model 639 with CODE FR8 (Backup assist (rearview camera)) and with CODE W65 (Liftgate)

4

Electrical connector

X18/62

Tailgate license plate lamp connector

X18/63

Electrical connector for rear-end door license plate lamp (without code W65 (Liftgate))

X169/5

INR/COC backup camera connector

 Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

 Danger

Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)

Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.

AS00.00-Z-0035-01A

Topical note

General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system

AH00.00-Z-0300-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

 

Remove/install

1

Switch off ignition and remove transmitter key from electronic ignition lock control unit

Model 639.603/703 with engine 780.994
with code MA0 (E-CELL 60 kW)


Do not begin working on electrical or electronic components earlier than 1 min after switching off the ignition.
Otherwise faults could occur in the battery management system.

2

Remove rear door foil or liftgate

AR72.20-S-4100S

3

Detach electrical connections (3)

Model 639.### ## up to 094908

4

Disconnect connector from INR/COC reversing camera (X169/5)

Model 636, 639
with code FR8 (Rear view camera)

5.1

Disconnect connector from liftgate license plate (X18/62)

Model 636, 639
with code W65 (Tailgate)

5.2

Disconnect rear door license plate connector (X18/63)

Model 636, 639
except code W65 (Tailgate)

6

Disconnect electrical connection (4)

Model 636, 639
with code FR8 (Rear view camera)

7

Unscrew nuts (1)

8

Unclip license plate lamp bracket (2) (arrows)

 Installation: Check retaining clips for damage, replace if necessary.

9

Disconnect electrical connectors from left license plate lamp and right license plate lamp

Model 636
Model 639.### ## as of 094909

10.1

Unclip license plate lamp

Model 636
Model 639.### ## as of 094909
Only when replacing license plate lamp holder (2).

10.2

Modify license plate lamp bracket (2)

Model 639.### ## up to 094908
Only when replacing license plate lamp holder (2).



AN72.20-S-0006S

11

Install in the reverse order



Check

12

Check electric loads for proper function