Remove/install rear-end door · ar7220p3500mce · Mercedes-Benz WIS

AR72.20-P-3500MCE

Remove/install rear-end door

4.10.07

MODEL 451.3

P72.20-2660-09

1 Rear-end door wiring harness

2 Side trunk lining

3 Pulling aid

7 Gas-operated strut

8 Rear-end door

9 Grommet

4 Door hinge

5 Screw

6 Retainer

 	Remove/install
1	Remove cover on left side luggage compartment paneling (2).
2	Guide rear-end door wiring harness (1) out of body opening
3	Push back foam rubber jacketing (arrow) and disconnect all electrical connectors as well as water fluid hose on rear-end door wiring harness (1).
4	Loosen grommet (9) on rear-end door wiring harness (1) in area of left door hinge (4).	 Installation: Arrow on grommet (9) should coincide with marking on body.
5	Fasten suitable pulling out (3) on rear-end door wiring harness (1) and guide rear-end door (1) upward out of vehicle.
 Danger!	Risk of injury Gas pressure struts are under high pressure and can pinch and crush body parts during work	Remove and install gas pressure struts only in relaxed position and on components properly secured.	AS00.00-Z-0012-01A
6	Lift retainers (6) with suitable screwdriver and unclip gas-operated strut (7) on rear-end door (8).	 Ensure that rear-end door (8) does not close unintentionally to prevent damage. Do not remove retainers (6) because otherwise tension on retainers (6) is lost.
		 Installation: Clip gas-operated strut (7) to ball heads on rear-end door (8) using retainers (6) clipped in.
7	Remove bolts (5) from door hinges (4) and take off rear-end door (8).	 Aid of helper required.
		 Installation: Check gaps on rear-end door (8), adjust if necessary.$ Refer to: 
		Adjust rear-end door (8)	AR72.20-P-3510MCD
			*BA72.20-P-1006-02F
8	Remove rear-end door wiper motor	When replacing rear-end door (8).	AR82.30-P-6900MCC
9	Remove center high-mounted brake lamp	When replacing rear-end door (8).	AR82.10-P-5375MCC
10	Remove rear spoiler	When replacing rear-end door (8).	AR88.30-P-0500MCC
11	Remove ball heads from gas-operated struts (7).	When replacing rear-end door (8).
			*BA72.20-P-1008-02F
12	Expose rear-end door wiring harness (1) on rear-end door (8) and remove.	When replacing rear-end door (8).
13	Install in the reverse order
14	Check rear window heater, rear wiper system and center high-mounted brake lamp for proper function

 Rear-end door

Number	Designation		Model 451.3


BA72.20-P-1006-02F	Bolt, hinge to glass pane	Nm	12
BA72.20-P-1008-02F	Gas-operated spring ball head to upper rear-end door	Nm	12

Henviste dokumenter

ar7220p3510mcd
ar8210p5375mcc
ar8230p6900mcc
ar8830p0500mcc
as0000z001201a Fare for personskade på grund af fastklemning eller knusning ved arbejde på gastrykfjedre, som står under forspænding.