P72.20-2628-06
Illustrated on model 451.4
1 Rear-end door
2 Retaining clamp
3 Rear-end door wiring harness
4 Cover
5 Electrical connector
6 Grommet
M14/7 Rear-end door CL [ZV] motor
P72.20-2629-06
Illustrated on model 451.4
1 Rear-end door
7 Nut
8 Bolt
| Remove/install | ||
1 | Remove door paneling from rear-end door (1). | ||
2 | Remove covers (4) from left and right door lock on rear-end door (1). | ||
3 | Separate electrical connector (5) | On model 451.3 the electrical connector (5) is located in the marked area (arrow). | |
4 | Disconnect electrical connector from rear-end door CL motor (M14/7) | ||
5 | Loosen retaining clamp (2) from rear-end door wiring harness (3) and expose rear-end door wiring harness (3) on rear-end door (1). | ||
6 | Loosen grommet (6) on rear-end door (1) | ||
7 | Open rear-end door (1) and loosen bolt (8) on left and right door check strap on rear-end door (1). | The bolt (8) remains on the corresponding door check strap. | |
| |||
8 | Lift load compartment floor covering, unscrew nut (7) on left and right hinge on rear-end door (1) and remove rear-end door (1). | | |
9 | Remove rear-end door CL motor (M14/7) | When replacing rear-end door (1). | |
10 | Remove inner cover from rear-end door (1) | When replacing rear-end door (1). | |
11 | Remove door locks on rear-end door (1). | When replacing rear-end door (1). | |
Door lock on upper rear-end door on model 451.3 | |||
Door lock on lower rear-end door on model 451.3 | |||
Model 451.4 | |||
12 | Unclip cable on rear-end door (1) and remove. | When replacing rear-end door (1). | |
On model 451.3 only one cable is installed on the rear-end door (1). | |||
13 | Remove foam rubber insert for arresting removed side supports from rear-end door (1). | When replacing rear-end door (1) on model 451.4. | |
14 | Install in the reverse order | ||
15 | Adjust rear-end door (1) |
Tailgate