AR72.20-D-2411A | Disassemble/assemble rear-end door (right door wing) | 25.11.10 |
MODEL 901.06 /36 /37 /46 /66 /67, 902.06 /07 /36 /37 /46 /47 /66 /67, 903.06 /07 /36 /37 /46 /47 /66 /67, 904.06 /36 /46 /66 except CODE (W90) No rear-end doors
MODEL 690.63/ 64
D72.20-1171-09
1 Closing wedge, top
2 Screw
3 Screw
4 Liftgate hinge
5 Inside door opener covering
6 Screw
7 Inside door opener
14 Screw
15 Door lock
16 Rivet
17 Closing wedge, bottom
18 Outer door handle
19 Screw
8 Door trim
9 Screw
10 Door catch
11 Mounting console (only with high roof with
code W54)
12 Tapping plate
13 Release cable
| Disassemble/assemble | ||
1 | Remove inside door opener (7) | ||
2.1 | Remove door paneling (8) from rear door | Except freezer vehicle or refrigerator vehicle, code ZA5 or ZA8 | |
2.2 | Remove insulating element for rear door | On freezer vehicle or refrigerator vehicle, code ZA5 or ZA8 | |
3 | Remove door lock (15) | ||
4 | Unscrew bolt (19) for door handle (18) | | |
5 | Slide door handle (18) to right and remove | Installation: Insert door handle (18) and push to left until the 3 catches arrest on the inside. | |
6 | Drill out rivet (16) of bottom closing wedge (17). | Use drill bit with diameter 4.8 mm. | |
7 | Remove closing wedge | ||
8 | Remove top closing wedge (1) | | |
9 | Remove door catch (10). | Installation: Observe installation position of tapping plate (28). Check adjustment of door catch in relation to counterpart. | |
Install door catch (10) | Except 2-wing rear door, 270 degrees, code W54 | ||
On 2-wing rear door, 270 degrees, code W54 | |||
| |||
10 | Remove door hinges (4) | Socket wrench bit T40, 70 mm shank length | |
| |||
11 | Assemble in the reverse order |
Rear-end door