Test values for sliding doors
Number | Designation | Models | |
BE72.16-N-1001-01A | Door gap all around | mm | 7 (0.5) |
Sliding doors
Number | Designation | Models | ||
BA72.16-N-1004-01A | Screw for bottom carriage on sliding door | Nm | 25 | |
BA72.16-N-1005-01A | Screw, upper carriage to sliding door | Nm | 25 | |
BA72.16-N-1011-01A | Screw, center carriage to sliding door | Hexagon socket | Nm | 45 |
Torx | Nm | 60 | ||
BA72.16-N-1014-01A | Bolt, striker bolt to B-pillar | Nm | 25 | |
D72.16-0003-02
A Ridge pattern
B, C Gap dimensions
D72.16-0018-01
Adjust ridge pattern A
1 Loosen screw (3) and adjust rear ridge pattern B by lifting or lowering sliding door.
2 Tighten bolt (3).
D72.16-0002-01
3 Loosen Torx bolts (1, 2) on upper and lower carriage.
4 Match front ridge pattern A at upper carriage by lifting or lowering sliding door.
5 Tighten Torx bolts (1, 2)
D72.16-0001-01
6 Loosen Torx screws (8) for locking eye and adapt to modified door adjustment by vertically adjusting (arrow) locking eye.
7 Tighten Torx bolts (8).
Do not lift or pull down sliding door over locking eye.When the ridge pattern coincides the bottom and top door gap B on the sliding door should be within the specified tolerance range. For optical reasons, a slightly wedge-shaped door gap at the top and bottom is preferable to a ridge offset.
D72.16-0009-01
Adjust gap C.
8 Loosen screw (3) and adjust gap C by horizontally adjusting center carriage (arrow).
9 Tighten bolt (3).