AR72.10-P-1000M | Remove/install door lining on front door | 11.9.97 |
MODEL 220
except CODE (Z07) Top protection
except CODE (Z04) Light armoring
P72.10-0579-09
Shown on model 220 up to VIN: 316716
1 Trim strip
2 Covering
3 Door handle cover
4 Door lining
9 Fastening clips
10 Screw
11 Screw
12 Cover
13 Screw
5 Cover on switch group
6 Screw
7 Lock rosette
8 Inner door panel
P72.10-2733-07
Shown on model 220 up to VIN: 316716
1 Trim strip
15 Bolts
17 Cap
2 Covering
3 Door handle cover
P72.10-2729-07
Shown on model 220 As of VIN: 316717
1 Trim strip
15 Bolts
16 Door opener cover
2 Covering
P72.10-0581-01
Shown on model 220 up to VIN: 316716
2 Covering
N69/1 Left front door control unit
N69/2 Right front door control unit
| Remove/Install | ||
1 | Press trim strip (1) out of covering (2) | | |
2.1 | Remove door handle cover (3) from door handle | Up to VIN :316716 | |
2.2 | Remove door opener cover (16) | As of VIN: 316717 | |
3.1 | Unclip cap (17) | Up to VIN :316716 | |
4 | Remove screws (15) | ||
5 | Press covering (2) off of door lining (2) | | |
6 | Disconnect electrical connector from left front door control unit (N69/1) and right front door control unit (N69/2) | For this purpose, remove covering (2) | |
7 | Unclip cover on switch group (5) with switch group from door lining (4) | For this purpose, pull cover on switch group (5) downward at bottom edge until cover on switch group (5) can be removed | |
8 | Unscrew bolt (6) from round cover plate (7) | For this purpose, remove round cover plate (7) | |
9 | Unscrew bolts (10, 11) from inner door handle | ||
10 | Remove screw (13) | For this purpose, remove cover (12) | |
11 | Press door lining (4) off of inner door panel (8) | Move mounting wedge (14) directly to fastening clips (9) and ensure that the retainer tabs on the fastening clip (9) do not tear out of the door lining (4) | |
| |||
12 | Lift door lining (4) at top on sealing rail out of retaining clips and simultaneously pull away from inner door panel (8) | Installation: Remove fastening clips remaining on inner door panel (8) and install at corresponding point on door lining (4) | |
| |||
13 | Unhook Bowden cable from inside door opener | ||
14 | Disconnect electrical connectors from door lining (4) and lay down door lining (4) | ||
15 | Check door foil and fastening clips (9) | Installation: Replace damaged door foil and fastening clips (9) | |
16 | Install in the reverse order |
Mounting wedge
110 589 03 59 00