Remove/install lower hinge of front passenger door · ar7210p0004lwe · Mercedes-Benz WIS

AR72.10-P-0004LWE

Remove/install lower hinge of front passenger door

16.04.2019

Model	205.0/1/2
Model	213
Model	253
Model	293

Remove/install lower hinge of front passenger door

Shown on model 213.### 1#

1.1	Front passenger door hinge leaf
2	Bolts

P72.10-4608-03

Shown on model 213.### 1#

1.2	A-pillar hinge leaf

P72.10-4610-03

Shown on model 213.### 1#

3	Nuts
F1/3	Passenger-side A-pillar fuse box

P72.10-4609-06

 Warning	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove
1	Remove front passenger door.		AR72.10-P-0500LW
2	Mark installation position of front passenger door hinge leaf (1.1) and A-pillar hinge leaf (1.2).
3	Remove door sill trim		AR68.30-P-4100LW
4	Unclip front passenger side A-pillar fuse box (F1/3) from A-pillar (arrows) and set aside.	 Do not disconnect electrical lines.
5	Unscrew nuts (3), release A-pillar hinge leaf (1.2) and remove.	 Long wedge	*115589035900
6	Remove seal under A-pillar hinge leaf (1.2).
7	Clean A-pillar in area of hinge support.	Cleaner	*BR00.45-Z-1025-04A
8	Remove screws (2) and remove front passenger door hinge leaf (1.1).
	Install
9	Align front passenger door hinge leaf (1.1) by means of the previously applied markings on front passenger door and tighten screws (2).	 Screw/bolt, hinge to front door	*BA72.10-P-1001-01W
10	Align A-pillar hinge leaf (1.2) with seal on A-pillar by means of the previously applied markings and tighten nuts (3).	 Helper required for exact positioning and holding of A-pillar hinge leaf (1.2).
		 Nut, hinge to A-pillar	*BA72.10-P-1002-01W
11	Install front passenger door.		AR72.10-P-0500LW
12	Open and close front passenger door.	 The installation position of the passenger door may change later due to opening and closing.
	Check
13	Check gap dimensions at front passenger door, adjust if necessary.		AR72.10-P-0552LW
	Install
14	Repair paint damage at respective bolt heads.
15	Protect front passenger door and A-pillar in the area of hinge against corrosion.	Wax for engine compartment (400 ml spray can)	*BR00.45-Z-1018-05A
16	Clip front passenger side A-pillar fuse box (F1/3) into A-pillar.
17	Install door sill trim.		AR68.30-P-4100LW

 Front door

Number	Designation		Model 205.0/1/2	Model 213
BA72.10-P-1001-01W	Screw/bolt, hinge to front door	Nm	34	34

 Front door

Number	Designation		Model 253	Model 293
BA72.10-P-1001-01W	Screw/bolt, hinge to front door	Nm	34	34

 Front door

Number	Designation		Model 205.0/1/2	Model 213
BA72.10-P-1002-01W	Nut, hinge to A-pillar	Nm	34	34

 Front door

Number	Designation		Model 253	Model 293
BA72.10-P-1002-01W	Nut, hinge to A-pillar	Nm	34	34

115 589 03 59 00

Long wedge

Repair materials

Number	Designation	Order number
BR00.45-Z-1018-05A	Wax for engine compartment (400 ml spray can)	A 000 986 33 70 10
BR00.45-Z-1025-04A	Cleaner	A 005 989 19 71

Henviste dokumenter

ah0000z001901a Oplysninger om sikkerhedsrelevante komponenter
ar6830p4100lw
ar7210p0500lw
ar7210p0500lwo
ar7210p0500lwr
ar7210p0552lw
ar7210p0552lwo
as0000z001101a Fare for personskade pga. fastklemning eller knusning af fingre ved af-, påmontering og indstillingsarbejde på motorhjelm og bagklap, døre, dæksler og soltag.