Remove/install trunk partition

AR68.50-P-3003LWR

Remove/install trunk partition

02.05.2017

Model

205.4, 238.4

1

Trunk partition

5

Sun blind shaft

2

Partition

6

Bolts

3

Locating block

7

Screw

4

Guide rail

8

Bearing

 Warning

Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities.

No parts of the body or limbs should be within the operating area of mechanical components when moving components.

AS00.00-Z-0009-01A

 Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

 Warning

Risk of injury when performing check and repair work in area of roll bar

Keep body parts out of the area where the roll bars extend.
Do not use the cover in the area of the roll bar as a storage place for objects.

AS91.00-Z-0003-01LCA

 

Remove/install

1

Move soft top to repair position R2

AR77.30-P-1030LWR

2

Cover rear and left right fender

3

Fold trunk partition (1) up

4

Unhook cords on left and right partition (2) and remove partitions (2)

5

Insert fastening block (3) into left and right guide rail (4) (arrow)

 The blind shaft (5) is arrested by the fastening block (3) in the left and right guide rail (4).
It might be necessary to slightly lift the blind shaft (5) by hand so that the fastening block (3) can be inserted into the intended hole pattern.

 Locating block

*207589022300

6

Unscrew bolts (6) from left and right guide rail (4)

7

Unscrew bolt (7) from left and right bearing (8)

8

Unhook left and right bearing (8) and remove trunk partition (1) together with left and right guide rail (4) from vehicle

9

Install in the reverse order