Remove/install side paneling in trunk

AR68.30-P-4800RG

Remove/install side paneling in trunk

03.03.2020

Model

190.3

1

Trunk lining

2

Trunk lining

3

Frame seal

4

Screw

5

Bracket

6

Partition net

7

Service flap

8

Expansion rivet

9

Clip

 Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

 Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

 

Remove/install

1

Remove rear-end center-section trim.

AR68.30-P-4785RG

2

Remove C-pillar trim.

AR68.30-P-4490RG

3

Remove screw (4) and remove bracket (5).

4

Unclip partitioning net (6) and remove.

Only when removing trunk paneling (1).

5

Open service flap (7), unhook, and remove.

Only when removing trunk paneling (1).

6

Remove the expansion rivet (8).

 The number of expansion rivets (8) varies depending on the model year.

 Clip remover

*452589016300

7

Release sealing frame (3) in the working area.

 Installation: Ensure that sealing frame (3) is seated correctly.

8

Unclip corresponding trunk lining (1 or 2) in the area of the clips (9).

 The number of clips (9) varies depending on the vehicle equipment.

9

Remove corresponding trunk lining (1 or 2).

10

Install in the reverse order.