ar6830p430505p

Install make-up mirror illumination wiring harness in headliner

Type ar · emne 68.30 · version 0101 · 2010-03-29

Gælder for: MODEL 203.0 /2 /7 with CODE (543) Sun visors with illuminated mirror

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 3 Karrosseri › 68 Indvendig udrustning › 68.30 Beklædninger, pynterammer — Serie 203 (modeller 0**, 2**, 7**)

EinPAS 30 Belysningsanlæg › 30.20 Indvendig belysning › 30.20.12 Sensor/kontakt/ledningssæt — Serie 203 (modeller 0**, 2**, 7**)

AR68.30-P-4305-05P

Install make-up mirror illumination wiring harness in headliner

Repair materials

Number

Designation

Order number

BR00.45-Z-1071-02A

Adhesive tape roll, gray Tesa tape, 50 meters 0.3X50, 236 mm

A 001 989 17 85

Install make-up mirror illumination wiring harness in headliner

P68.30-2632-11

1 Unclip covers for sun visor pivot bearing (4) from new make-up mirror illumination wiring harness (2) and install sun visor pivot bearing (4) on new headliner (1), then clip in covers.

Observe routing of electrical connections (10) to overhead control panel control module. The old headliner (1) serves as a guide for routing the wiring harness.

2 Route new make-up mirror illumination wiring harness (3) and glue with approx. 10 cm long strip of adhesive tape at a distance of approx. 10 cm onto new headliner (1)

Press strips of adhesive tape on sufficiently, otherwise the make-up mirror illumination wiring harness (3) can loosen.

3 In the area of the new installation frame, connect right and left electrical connector for new make-up mirror illumination wiring harness (3) with left and right illumination for make-up mirror, then clip left and right make-up mirror illumination into new installation frame.