1 | Headliner |
2 | Sun visor |
3 | Cover |
4 | A-pillar trim panel |
5 | C-pillar paneling |
6 | Edge guard |
7 | Coat hook |
A67 | Inside rearview mirror |
P68.30-3985-12
12 | Foam material |
13 | Electrical connector |
P68.20-4994-05
| Remove/install | ||
1 | Open all of the side windows. | ||
2 | Completely open roller sun blind on panoramic roof | Model 238.3 | |
3 | Remove inside rearview mirror (A67) | ||
4 | Fold back the foam material (12) and die disconnect the electrical connection (13). | Installation: | |
5 | Remove left and right sun visor (2). | ||
6 | Unclip the left and right cover (3) from the headliner (1). | ||
7 | Remove the left and right A-pillar paneling (4). | ||
8 | Remove the left and right coat hook (7) and unscrew the bolts below. | ||
9 | Remove the left and right C-pillar paneling (5) and lay it down to the side with the installed seat belts | ||
10 | Remove the edge guards (6) from the body flange in the area of the headliner (1). | ||
11 | Put the backrests on the two front seats all the way down. | ||
12 | Press the catch hooks (arrows) together and unclip the headliner (1) from the front roof frame. | ||
13 | Push headliner (1) toward rear until guide hooks are unhooked from rear roof frame and lay headliner (1) down on vehicle | Helper required. | |
14 | Remove the headliner (1) from the vehicle from the side. | | |
Helper required. | |||
15 | Make sure that all of the soundproofing on the headliner (1) is properly attached and in good condition. | Model 238.3 | |
If complaint present | |||
| |||
Replace the affected soundproofing on the headliner (1). | |||
16 | Prepare new headliner (1) for installation | When replacing roof paneling (1). | |
Adhesive tape roll, non-woven Tesa tape, 50 meters, 50 mm wide | |||
17 | Install in the reverse order |