ar6830p430008q

Prepare headliner for installing TELE AID

Type ar · emne 68.30 · version 0101 · 2010-03-29

Gælder for: MODEL 209.3 with CODE (855) TELE AID

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 3 Karrosseri › 68 Indvendig udrustning › 68.30 Beklædninger, pynterammer — Serie 209 (modeller 3**)

EinPAS 37 Indvendigt udstyr › 37.45 Beklædning › 37.45.32 loftsbeklædning — Serie 209 (modeller 3**)

AR68.30-P-4300-08Q

Prepare headliner for installing TELE AID

Repair materials

Number

Designation

Order number

BR00.45-Z-1071-02A

Adhesive tape roll, gray Tesa tape, 50 meters 0.3X50, 236 mm

A 001 989 17 85

Prepare headliner for installing TELE AID

P68.30-2814-06

Shown on model 209.3 with code (414a) Electric glass tilting/sliding roof and code (220a) Parktronic system (PTS) and code (882b) Interior monitoring (only with ATA)

1 Headliner

2 Sound system wiring harness (with code (810) Sound system)

3 TELE AID wiring harness

1 Lay new headliner (1) down on suitable subsurface.

2 Place suitable clean spacers, e.g. foamed material or styrofoam pads below new headliner.

Do not use any hard or sharp-edged objects, otherwise covering of new headliner (1) will be damaged.

The foamed material or styrofoam pads prevent the new headliner (1) from sagging when performing the following steps.

3 Route new TELE AID wiring harness (3) on new headliner (1) starting at overhead control panel control module opening.

The old headliner (1) serves as template for routing the wiring harness.

4 Glue new TELE AID wiring harness (3) onto new headliner (1) with approx. 10 cm long strips of adhesive tape at an interval of approx. 10 cm.

Do not overcross new TELE AID wiring harness (3) and sound system wiring harness (2) (with code (810) Sound system) and sufficiently press on strips of adhesive tape, otherwise a short circuit on the headliner can result from chafing.