ar6830p430004m

Prepare headliner for installing Parktronic system warning display in rear

Type ar · emne 68.30 · version 0100 · 2006-07-25

Gælder for: MODEL 220.0 /1 with CODE (220a) Parktronic System (PTS)

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 3 Karrosseri › 68 Indvendig udrustning › 68.30 Beklædninger, pynterammer — Serie 220 (modeller 0**, 1**)

EinPAS 37 Indvendigt udstyr › 37.45 Beklædning › 37.45.32 loftsbeklædning — Serie 220 (modeller 0**, 1**)

AR68.30-P-4300-04M

Prepare headliner for installing Parktronic system warning display in rear

Model 220.0/1

Workshop equipment

WE58.40-Z-1004-03A

Body saw (electric/pneumatic)

Prepare headliner for installing Parktronic system warning display in rear

P68.30-2789-06

Illustrated on model 220.1 with code (414a) Electric glass sliding/pop-up roof and code (220a) Parktronic system and code (882b) Infrared interior monitoring (only with ATA)

1 Roof paneling

2 Felt strip

3 Cutting area

4 Template

5 IRS installation frame (with code (882b) Infrared interior monitoring (only with ATA))

6 Main wiring harness

7 PTS installation frame

8 Cutting area

9 PTS wiring harness connection

10 IRS wiring harness connection

1 Lay old headliner (1) down on suitable subsurface.

2 Remove PTS installation frame (7) from old headliner (1).

3 Loosen main wiring harness (6) and felt strips (2) from old headliner (1) in cutting area (3, 8) and lay down to side.

4 Fabricate template (4), for this purpose, saw through old roof paneling (1) approximately in cut area (8) and then approximately in cut area (3).

5 Lay new headliner (1) down on suitable clean subsurface.

6 Support new headliner (1) in area of cutout for PTS installation frame (7) with suitable spacers, e.g. foam rubber or Styrofoam blocks.

Do not use any hard or sharp-edge objects, otherwise the covering of the new headliner (1) can be damaged

-----------------------------------------------------------------------------------------

This prevents the new headliner (1) from bending when performing the following steps

7 Lay template (4) down on new headliner (1), align and transfer cutout for PTS installation frame (7) from template (4) to new headliner (1)

8 Remove template (4) from new headliner (1) and cut hole in new headliner (1) for PTS installation frame (7).

Use metal saw blade.

Saw out within recorded cutting line, otherwise the cutout for the PTS installation frame (7) is too large.

9 Insert PTS installation frame (7) from below into new headliner (1)

-----------------------------------------------------------------------------------------

10 Bend retaining lugs of PTS installation frame (7) with plastic mallet

Carefully position tool at PTS installation frame (7), otherwise headliner (1) can be soiled or damaged. Thereby support PTS installation frame (7) with suitable clean object from below, otherwise installation frame (7) can distort