Remove/install center module

AR68.10-W-1005HA

Remove/install center module

20.03.2020

Model

963, 964

with code F2A (Floor variant, flat floor)

except code F2B (Floor variant, tunnel 170 mm)

except code F2C (Floor variant, tunnel 320 mm)

Shown on vehicle with two sockets and without code D7K (Drawer, under dash support)

1

Center module

2

Lower stowage compartment

3

Insert

4

Screw

X137.3

Footwell socket: 12 V

X168.3

Footwell socket: 24 V

Notes on safety-relevant components

AH00.00-Z-0019-01A

 

Remove/install

1.1

Remove insert (3) from bottom stowage compartment (2).

Vehicles without code D7K (Drawer, under dash support)

1.2

Pull out bottom drawer in center module (1) and remove insert.

Vehicles with code D7K (Drawer, under dash support)

 The screws (4) for fastening the center module (1) are accessible via the two cutouts at the back of the floor of the bottom drawer.

2

Remove screws (4).

 Screw, center module to carrier plate for center module

*BA68.10-N-1004-03A

3

Pull out center module (1).

4

Switch off ignition.

Only on vehicles with sockets in center module (1).

5

Disconnect electrical connectors on the sockets in the center module (1).

Only on vehicles with sockets in center module (1).

 The pictures shows the 12 V footwell socket (X137.3) and the 24 V footwell socket (X168.3) installed in the center module (1).

6

Install in the reverse order

 Center module

Number

Designation

Model 963, 964

BA68.10-N-1004-03A

Screw, center module to carrier plate for center module

Nm

8