Remove/install bottom paneling for dashboard on driver side

AR68.10-P-1501FR

Remove/install bottom paneling for dashboard on driver side

25.04.2018

Model

257, 290

Shown on model 257.### 1#

1

Cover

7

Electrical connector

2

Engine hood release handle

8

Screw

3

Bolts

B10/35

Left footwell air outlet temperature sensor

4

Electrical connector

E17/16

Left front footwell lamp

5

Electrical connector

H4/61

Instrument cluster speaker

6

Electrical connector

X11/4

Diagnostic connector

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

 

Remove/install

1

Adjust steering column upward.

2

Adjust driver seat to the rear.

3

Switch off ignition and store transmitter key outside of transmission range (min. 2  m).

4

Remove front door sill.

5

Remove screw/bolts (3).

6

Loosen trim (1) and lower (arrow A) until electrical connectors (4, 5, 6, 7) are accessible.

 Long wedge

*115589035900

7

Disconnect electrical connectors (4, 5, 6, 7).

8

Remove screw/bolt (8).

9

Remove engine hood release handle (2) to the rear out of trim (1).

10

Unhook retaining tab of trim (1) from floor covering (arrow B) and remove trim (1).

11

Remove diagnostics connection (X11/4).

When replacing trim (1).

12

Remove instrument cluster speaker (H4/61).

When replacing trim (1).

13

Remove left footwell vent air outlet temperature sensor (B10/35) or right footwell vent air outlet temperature sensor.

When replacing trim (1).

14

Remove left front footwell lamp (E17/16) or right front footwell lamp.

When replacing trim (1).

15

Install in the reverse order.