S67.10-4520-08
1 | Remove residual adhesive material from windshield (1). |
When reusing windshield (1). |
A maximum of 1 mm may be left. Pull off loose adhesive residues (remaining adhesive residues not completely cut off). |
2 | Clean windshield (1) with commercially available glass cleaner. |
The bonding area on the windshield (1) must be absolutely dry, and free of dust and grease. |
3 | Check windshield (1) for damage. |
When reusing windshield (1). |
If the windshield (1) is damaged, |
|
Replace windshield (1). |
4 | Clean bonding area on the windshield (1) with the cleaner contained in the repair kit and cleaning cloth and rub dry with dry cloth. |
When replacing windshield (1). |
5 | Glue on window seal (4) along the installation marks (area A). |
S67.10-4521-09
a | Height (12 mm) | b | Width (7 mm) |
6 | Prepare Teromix 6700 adhesive cartridge. |
Commercially available devices/tools |
7 | Apply Teromix 6700 adhesive to rubber cover (2). |
8 | Attach rubber cover (2) in top area of the windshield (1). |
9 | Glue on window seals (3) along the course of the windshield as shown. |
10 | Apply the primer included in the repair kit with slight pressure, in one stroke and in sufficient thickness to the bonding area on the windshield (1). |
When replacing windshield (1). |
Do not brush on primer and do not apply excessive coat thickness. Comply with flash-off time of 10 min. |
11 | Apply adhesive bead adjacent along the respective outside of the window seals (3, 4). |
Avoid multiple starts. The starts available through multiple starts must be connected with each other. |
Do not apply adhesive material too thickly. |
Observe the height (a) and width (b) of the adhesive bead. |
Commercially available devices/tools |