Remove/install detachable parts when replacing windshield

AR67.10-P-1050EC

Remove/install detachable parts when replacing windshield

15.03.2016

Model

204.3, 207

Shown on model 207.3 with code 413 (Panoramic sliding roof)

1

Windshield

2

Trim piece

3

Clip

10

Electrical connector (with code 863 (TV tuner digital/analog))

A94/3

TV 3 antenna amplifier (with code 863 (Digital/analog TV tuner))

Shown on model 207.3 except code 413 (Panoramic sliding sunroof)

1

Windshield

3

Clip

4

Drip rails

5

Clips

1

Windshield

6

Driver-side wiper arm

7

Passenger-side wiper arm

8

Retaining clips

9

Air-water duct

 Danger !

Injury hazard from pinching and crushing, in extreme cases extremities can even be cut off when caught in windshield wiper mechanism.

When working on the windshield wiper mechanism, always switch off the ignition and store transmitter key outside of transmission range (at least 2 m).

AS82.30-Z-0001-01A



Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

 

Remove/install

1

Completely open soft top

Model 207.4

2

Completely set up wind deflector

Model 207.4
with code 288 (Draft stop for convertible)

3.1

Unclip left and right trim piece (2) from bottom upward and remove

Model 207.4

 Installation: Ensure that trim piece (2) is seated correctly in clips (3).

 Long wedge

*115589035900

3.2

Unclip left and right drip rail (4) from rear toward front and remove

Model 204.3, 207
except code 413 (Automatic panoramic sliding sunroof)

 Installation: Ensure that drip rail (4) is seated correctly in clips (3).
Ensure that clips (5) are seated correctly on roof paneling.

 Long wedge

*115589035900

4

Remove driver-side wiper arm (6) and passenger-side wiper arm (7)

AR82.30-P-6100CW

5

Remove retaining clips (8) and unclip air/water duct

6

Place air/water duct (9) with connected lines to side

7.1

Remove A-pillar trim on left and right

Model 204.3, 207.4

Model 204.3

AR68.30-P-4050CW

7.2

Remove right A-pillar paneling

Model 207.3
with code 863 (Digital/analog TV tuner)

AR68.30-P-4050WX

8

Disconnect electrical connector (10) from TV 3 antenna amplifier (A94/3)

Model 207.3
with code 863 (Digital/analog TV tuner)

9

Disconnect electrical connector from left and right antenna amplifier

Model 207.4

10

Remove inside rearview mirror

Model 207.4

AR68.40-P-0001SX

11

Remove overhead control panel control unit and allow to hang down with lines connected

Model 207.4

AR82.20-P-1000CW

12

Install in the reverse order