The bonding area on the window (1) must be absolutely free of dust and grease.
Otherwise the adhesive force of the adhesive material starts to decrease when installing the window.
1 | Check window (1) for scratches and damage. |
When reusing window (1). |
If there are problems: | |
| |
Install new washer (1). |
2 | Fold over protective foil on inside of window (1) in lower toward inside area approx. 5 cm above screen print and fix in place on protective foil with suitable adhesive tape (arrows). |
When preparing windshield. |
Do not bond duct tape to protective coating on inside of window (1). |
Shown on windshield |
P67.10-2287-11
3 | Clean inside of window (1) in lower area of glass cleaner. |
When preparing windshield. |
This area will be visible later but is no longer accessible after installation. |
4 | Clean bonding areas on window (1). |
5 | Coat bonding areas on window (1) with activator. |
Observe flash-off time for activator. |
6 | Coat adhesive areas on window (1) with primer. |
7 | Attach duct tape (2) for support bead on window (1). |
When preparing windshield. |
8 | Fasten electrical line for windshield heater to window (1) with duct tape. |
When preparing window with windshield heater. |