Commercially available tools
Number | Designation | |
WH58.30-Z-1003-01A | Electrode miller | |
WH58.30-Z-1003-02A | Clamping pliers | |
WH58.30-Z-1031-02A | C-clamp | |
WH58.30-Z-1001-03A | Round wire brush, braided, dia. 70 mm | |
WH58.30-Z-1024-04A | Abrasive disk, dia. 115 mm, 80 m/s (max. 13,250 rpm) | |
WH58.30-Z-1001-40A | Tarp (fire-resistant) |
Workshop equipment
WE58.40-Z-1005-01C | Celette straightening bracket set, CC 7970 |
WE58.40-Z-1001-01E | Celette straightening bench |
WE58.40-Z-1001-02A | Inert gas welder |
WE58.40-Z-1002-02A | Spot welder |
WE58.40-Z-1001-03A | Drill (electric/pneumatic) |
WE58.40-Z-1003-03A | Angle grinder (electric/pneumatic) |
WE58.40-Z-1005-03A | Wet/dry vacuum cleaner |
W64.20-1049-06
1 Install rear cross member inner section, fit and fasten with clamping pliers.
2 Rear cross member inner section in areas A to C .
W64.20-1053-09
3 Fit gusset plates on left and right with straightening tool (arrows) and fasten with clamping pliers.
4 Tack weld gusset plates with a number of spot welds.
W64.20-1059-09
5 Remove rear straightening set.
6 Gusset plates in areas D to G .
Weld gusset plates in areas D to E exactly to sheet metal lugs.
7 Rear cross member in area H .
W64.20-1065-09
8 Rear cross member in areas I to L .
9 Clean all welds with wire brush.
W64.20-1071-09
10 Install rear cross member outer section with straightening tool, fit and fasten.
11 Cross member outer section in areas M to T .
12 Cross member outer section in areas U to X .
13 Clean all welds with wire brush.
Do not grind welds located in concealed areas for reasons of operating strength and cost.