Commercially available tools
Number | Designation | |
WH58.30-Z-1003-01A | Electrode miller | |
WH58.30-Z-1003-02A | Clamping pliers | |
WH58.30-Z-1031-02A | C-clamp | |
WH58.30-Z-1001-03A | Round wire brush, braided, dia. 70 mm | |
WH58.30-Z-1024-04A | Abrasive disk, dia. 115 mm, 80 m/s (max. 13,250 rpm) | |
WH58.30-Z-1001-40A | Tarp (fire-resistant) |
Workshop equipment
WE58.40-Z-1001-02A | Inert gas welder |
WE58.40-Z-1002-02A | Spot welder |
WE58.40-Z-1001-03A | Drill (electric/pneumatic) |
WE58.40-Z-1003-03A | Angle grinder (electric/pneumatic) |
WE58.40-Z-1005-03A | Wet/dry vacuum cleaner |
W64.10-1049-06
1 Fit rear wall paneling and fasten with clamping pliers.
2 Fasten rear wall paneling to cross member with sheet metal screws and washers at several points (arrows).
3 Rear wall paneling in areas A and B .
W64.10-1054-09
4 Rear wall paneling in areas C to E .
W64.10-1063-09
5 Rear wall paneling in areas F and H .
6.1 Rear wall paneling in areas G and I .
With code (F07) short cab.
6.2 Rear wall paneling in areas G and I .
With code (F04) long cab.
W64.10-1059-06
7 Fit left and right reinforcement and fasten with clamping pliers.
8 Reinforcements in areas K and L .
9 Reinforcements and inner side wall section in areas J and M .
10 Clean all welds with wire brush.
Do not grind welds located in concealed areas for reasons of operating strength and cost.
W64.10-1067-06
11 Insert rear wall cover into both openings and rivet with one pop rivet each (arrows).