The following steps are shown on the left side of the vehicle and must be performed analogously on the right side in the event of damage.
P63.50-4140-09
1 | Install rear fender (1) and fit. |
2 | Install rear bumper. |
3 | Install trunk lid. |
4 | Install rear lamp. |
5 | Install door seal. |
6 | Check and adjust gap dimensions. |
7 | Fix rear fender (1) in place. |
8 | Remove door seal. |
9 | Remove taillamp. |
10 | Remove trunk lid. |
11 | Remove rear bumper. |
12 | Drill rivet holes on rear fender (1) with Ø 6.7 mm bit (areas A). |
13 | Remove rear fender (1). |
14 | Deburr rivet holes on rear fender (1) and body on both sides. |
P63.50-4141-09
15 | Apply sealant to outer rear wheel well in crosshatched areas to foam part and body (areas C and D). |
16 | Apply 2-component adhesive to body in crosshatched areas (areas B). |
Observe pretreatment of bonding surfaces. Observe manufacturer's specifications for drying and processing time of adhesive. |
P63.50-4142-09
17 | Install rear fender (1) and fix in place. |
18 | Rivet rear fender (1) with Ø 6.5x14.5 rivet (areas E1). |
Clamping range 5 mm. |
19 | Rivet rear fender (1) with Ø 6.5x14.5 rivet (area E2). |
Clamping range 5 mm to 6.5 mm. |
20 | Rivet rear fender (1) with Ø 6.5x12.5 (area E3). |
Clamping range 3.5 mm. |
21 | Rear fender (1) (areas F). |
22 | Rear fender (1) (areas G). |
P63.50-4143-06
23 | Rear fender (1) (areas H). |
24 | Rear fender (1) (area I). |
P63.50-4144-06