ar5465s000102ea

Remove/install sensors for center Parktronic system (PTS) in front bumper

Type ar · emne 54.65 · version 0101 · 2018-10-26

Gælder for: Model 447.8, 448.8 with code EZ7 (Active Parking Assist) with code PS2 (AMG line)

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 2 Chassis › 54 El-system, udrustning og instrumenter › 54.65 Parkeringshjælp — Serie 447 (modeller 8**) · Serie 448 (modeller 8**)

EinPAS 28 Komfort-/førerassistancesystem › 28.15 parkeringsassistent › 28.15.12 Sensor/kontakt/ledningssæt — Serie 447 (modeller 8**) · Serie 448 (modeller 8**)

AR54.65-S-0001-02EA

Remove/install sensors for center Parktronic system (PTS) in front bumper

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Model

447.8, 448.8

with code EZ7 (Active Parking Assist)

with code PS2 (AMG line)

Remove/install sensors for center Parktronic system (PTS) in front bumper
Remove/install sensors for center Parktronic system (PTS) in front bumper

Work procedure shown on left side of vehicle

1

Remove expansion rivet (1) from left or right fender liner (2).


Installation: Check expansion rivet (1) for damage.


If there is damage,

replace corresponding expansion rivet (1).


S54.65-4574-01

S54.65-4575-01

Remove/install sensors for center Parktronic system (PTS) in front bumper

2

Push left or right fender liner (2) to one side until center left front PARKTRONIC sensor (B8/17) or center right front PARKTRONIC sensor (B8/20) is accessible.



3

Disconnect electrical connection at the center left front PARKTRONIC (B8/17) or the center right front PARKTRONIC sensor (B8/20).



4

Carefully press the catch hooks (arrows) outwards and pull center left front Parktronic sensor (B8/17) or the center right front Parktronic sensor (B8/20) out of the guide.


Installation: Convert decoupling ring (3) when replacing left front center PARKTRONIC sensor (B8/17) or right front center PARKTRONIC sensor (B8/20).
Check the decoupling ring (3) for damage.


If the decoupling ring (3) is damaged,

replace decoupling ring (3).



5

Install in the reverse order.


S54.65-4690-06

Henviste dokumenter