ar5418d7435tsr

Remove/install electrical wiring harness for front brakepad wear display

Type ar · emne 54.18 · version 0100 · 2018-05-12

Gælder for: Model 907

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 2 Chassis › 54 El-system, udrustning og instrumenter › 54.18 Ledningssæt — Serie 907

EinPAS 21 bremser/vakuumsystem/trykluftsystem › 21.15 driftsbremse/vakuumsystem › 21.15.12 Sensor/kontakt/ledningssæt — Serie 907

AR54.18-D-7435TSR

Remove/install electrical wiring harness for front brakepad wear display

27.04.2018

Model

907

Remove/install electrical wiring harness for front brakepad wear display

D54.18-1250-79

1

Electrical wiring harness

5

Cover

2

Screw

6

Cable tie

3

Electrical connector

7

Electrical connector

4

Nut

Topical note

Notes on repairs to brake system

AH42.00-P-0003-01A

Remove/install

1

Remove right front wheel.

AR40.10-D-1100TS

2

Remove screw (2) and remove electrical wiring harness (1) until electrical connector (3) is accessible.

Bolt, wiring harness for wear indicator to brake caliper

*BA42.10-N-1003-10TS

3

Disconnect electrical connector (3).

4

Open dust cap (arrow A) and loosen electrical wiring harness (1) from brake caliper.

5

Unclip electrical wiring harness (1) from holders (arrows B).

6

Unscrew nut (4).

7

Loosen trim (5) and fold back until electrical connector (7) and cable tie (6) are accessible.

8

Cut cable tie (6).

Installation: Use a new cable tie (6).

9

Detach electrical connector (7).

10

Unclip electrical wiring harness (1) using a suitable tool (arrow C) and remove.

11

Install in the reverse order.

Front axle brake caliper

Number

Designation

Model 907, 910

BA42.10-N-1003-10TS

Bolt, wiring harness for wear indicator to brake caliper

Nm

8

Henviste dokumenter