1 | Electrical connector |
2 | Fuel line |
3 | Filler cover |
4 | Tensioning strap |
5 | Fuel line (Additional fuel tank) |
B39 | Fuel level sensor |
W47.10-1087-06
4 | Tensioning strap |
6 | Pin |
7 | Nut |
8 | Support shims |
9 | Fuel tank |
10 | Mounting support |
11 | Plate |
12 | Chassis |
B47.10-A002-06
B47.10-A003-09
A | Holder | C | Holder | |
B | Holder | D | Holder |
| Remove | ||
1 | Remove the fuel tank (9) | ||
| |||
2 | Remove the lock of the pin (6) | ||
3 | Remove the pin (6) of the tensioning strap (4) | ||
4 | Remove the tensioning strap (4) | ||
5 | Remove the nuts (7) | ||
6 | Remove the mounting support (10) with the plate (11) | ||
7 | Detach the mounting support (10) from the plate (11) | ||
8 | Remove the support shims (8) | Only if necessary. | |
| Check | ||
9 | Check the rubber protections which wraps the mounting support (10) and the tensioning strap (4) | If the rubber protection is parched, cut, or have any damage type: | |
| |||
Replace them by new ones. | |||
| Install | ||
10 | Mount the mounting support (10) on the plate (11) | Bolts and nuts tightened in angle must be replaced by new ones. | |
Console nut on the support | |||
11 | Install the mounting support (10) with the plate (11) on the chassis (12) | Make sure the correct positioning, so that the fuel tank (9) is aligned with the chassis (12). | |
Bracket nut on the chassis | |||
12 | Install the tensioning strap (4) with the pin (6) | Use new locks on the pin (6). | |
13 | Install the fuel tank (9) |
|