A46.40-0009-06
1 Drag link
2 Hose clamp
3 Pitman arm
4 Joint
5 Steering gear pitman arm
6 Hose clamp
7 Joint
| Removing | ||
1 | Unlock nuts on the ball joint ends (4, 7) and loosen a few threads | The nuts which have been loosened secure the drag link (1) to prevent it from falling down when pressing off. | |
2 | Press off ball joint ends (4, 7) | The ball joint ends loosen suddenly. The position of the steering wheel must not be changed after removing the drag link. | |
| |||
3 | Unscrew nuts and remove drag link (1) | ||
| Install | ||
4 | Attach drag link (1) to steering gear pitman arm (5) and pitman arm (3) and check length | only if a new drag link has been installed or the position of the primary shaft on the steering gear has been corrected | |
It must be possible to attach ball joint ends (4, 7) free of tension, if necessary: Loosen clamps (2, 6) and adjust the length by evenly unscrewing or screwing in the two ball joint ends. | |||
5 | Install drag link (1) | | |
| |||
6 | Secure nuts | Install new cotter pins. | |
7 | Screw on clamps (2, 6) | Only if the length of the drag link (1) has been adjusted. | |
| |||
8 | Check and adjust wheel angle |
Tie rod
Number | Designation | Steering 766.422 in model 390.05 | ||
BA46.40-N-1002-01G | Nut, drag link to pitman arm | Nm | 250 | |
BA46.40-N-1003-01G | Nut, drag link to steering gear pitman arm | Nm | 250 | |
BA46.40-N-1005-01G | Nut, hose clamp to drag link | Nm | 70 | |
Puller
625 589 00 35 00