ar4625p309003f

Set center position of hydraulic limiter

Type ar · emne 46.25 · version 0105 · 2019-01-18

Gælder for: Model 460, 461 with steering gear 765.5 Model 463 with steering gear 765.5 up to model year 2019

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 2 Chassis › 46 Styretøj › 46.25 Hydraulisk/elektrohydraulisk styretøj — Serie 460 · Serie 461 · Serie 463

EinPAS 22 Styretøj › 22.15 Servostyring › 22.15.42 Styretøj/styreaksel — Serie 460 · Serie 461 · Serie 463

Gælder også for motorer/gearkasser: 765 5**

AR46.25-P-3090-03F

Set center position of hydraulic limiter

Model

460, 461 with steering gear 765.5

Model

463 with steering gear 765.5

up to model year 2019

Set center position of hydraulic limiter

Distance (A) is the distance between the stop screw (5) and the axle stop (6) when the hydraulic limiter is applied.
If different distances (A) were measured for the left steer and right steer, then the center position of the steering must be corrected by shortening or lengthening the drag link.
Here,the distance (A) for left steer must always be at least equal, if possible larger than for right steer. However, the mechanical axle stop must have correctly adjusted beforehand for this to happen.

P46.20-2290-11

Set center position of hydraulic limiter

Release counternut (2) on drag link (1).


In some model designations, the drag link (1) does not have any counternuts (2), but clamps (4) instead, as installed on the tie rod (3). In this case, release the clamps on the drag link (1).



Lengthen drag link (1) by turning.


Only if the distance (A) on the right wheel is too large and on the left wheel is too small.



Shorten drag link (1) by turning.


Only if the distance (A) on the right wheel is too small and on the left wheel is too large.



Check hydraulic limiter again.


P40.20-2218-11