W46.10-1058-08
1 | Steering column trim upper part, top | 4 | Bellows | 7 | Union sleeve | ||
2 | Steering column trim lower part, top | 5 | Reader electronics of immobilizer | 8 | Lock cylinder | ||
3 | Plastic frame | 6 | Key | 9 | Steering lock |
6 | Key |
7 | Union sleeve |
8 | Lock cylinder |
9 | Steering lock |
Pfeil A | Pin |
Pfeil B | Cutout |
W46.10-1059-11
| Remove | ||
1 | Position steering column to lowest position | ||
2 | Remove upper part of upper steering column trim (1) from lower part of upper steering column trim (2) and swivel downward to instrument cluster | ||
3 | Remove key (6) | ||
4 | Remove lower part of upper steering column trim (2) from the steering column bracket | ||
5 | Remove plastic frame (3) and take off lower part of upper steering column trim (2) | There are six plastic clamps on the plastic frame (3), with which the boot (4) is fastened to the lower part of the upper steering column trim (2). | |
6 | Disconnect the readout electronics of the immobilizer (5) from the steering lock (9) | ||
7 | Insert the key (6) into the lock cylinder (8) and turn to position 1 (circuit 15 R ON) | ||
8 | Loosen the union sleeve (7) of the lock cylinder (8) from the steering lock housing (9) by turning to the left or the right | When doing so, hold the key (6) firmly. | |
9 | Pull lock cylinder (8) out of the steering lock housing (9) together with the union sleeve (7) and key (6) | ||
10 | Remove key (6) and union sleeve (7) from the lock cylinder (8) | ||
| Install | ||
11 | Guide key (6) through the union sleeve (7) and insert into the lock cylinder (8) | ||
12 | Insert lock cylinder (8) into the steering lock housing (9) together with the union sleeve (7) and the key (6) | When inserting, ensure that the lock cylinder (8) is in the correct position. The pin (arrow A) on the lock cylinder (8) must engage in the notch (arrow B) in the steering lock (9). | |
13 | Turn union sleeve (7) approx. 90° to the left or to the right | When doing so, hold the key (6) firmly. | |
14 | Turn key (6) to position 0 (ignition OFF) and remove | When removing the key (6), the union sleeve (7) engages fully with the steering lock (9). | |
15 | Insert the readout electronics of the immobilizer (5) into the steering lock (9) | ||
16 | Attach boot (4) with plastic frame (3) to the lower part of the upper steering column trim (2) | ||
17 | Mount lower part of upper steering column trim (2) to the steering column bracket | ||
18 | Mount upper part of upper steering column trim (1) to lower part of upper steering column trim (2) | ||
19 | Teach in key (6) | Only if the key (6) is to be replaced. |