ar4310d0355ts

Remove/install brake booster vacuum line

Type ar · emne 43.10 · version 0100 · 2019-05-15

Gælder for: Model 910 with engine 651

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 2 Chassis › 43 Bremsepneumatik og hjælpebremser › 43.10 Bremsekraftforstærker pneumatisk — Serie 651 · Serie 910

EinPAS 21 bremser/vakuumsystem/trykluftsystem › 21.15 driftsbremse/vakuumsystem › 21.15.13 ledning/slange/ventil — Serie 651 · Serie 910

AR43.10-D-0355TS

Remove/install brake booster vacuum line

30.04.2019

Model

910 with engine 651

Remove/install brake booster vacuum line

D43.10-A000-78

1

Vacuum line

2

Brake booster

3

Line

Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Topical note

Notes on avoiding damage through contamination and foreign objects

AH00.00-P-5000-01A

Remove/install

1

Operate brake pedal several times with engine switched off.

This reduces the vacuum in the brake booster (2).

2

Remove vacuum line (1) from brake booster (2).

Seal connection on brake booster (2).

Installation: Inspect gasket for damage.

Record plug

*129589009100

If the seal is damaged,

replace seal.

3

Remove vacuum line (1).

To do so, remove vacuum line (1) from line (3) of vacuum pump and route out of engine compartment.
Seal connection on line (3).

Record plug

*129589009100

4

Install in the reverse order.

Check

5

Perform brake test.

Brake test

AP42.00-D-4290TS

Remove/install brake booster vacuum line

129 589 00 91 00

Record plug

Henviste dokumenter