Disconnect/connect electrical connector on Electronic Stability Program control unit · ar4245p000101mfa · Mercedes-Benz WIS

AR42.45-P-0001-01MFA	Disconnect/connect electrical connector on Electronic Stability Program control unit
Topical note	Information on preventing damage to electronic components due to electrostatic discharge	AH54.00-P-0001-01A
	Notes on safety-relevant components	AH00.00-Z-0019-01A

Model

118, 177, 247

 If there is damage on the bracket, plug or locks, replace corresponding component part.

Disconnect/connect electrical connector on Electronic Stability Program control
unit

P42.45-2816-09

Disconnect electrical connector

1	Slide gray lock (3) upwards.

 If there is damage on the bracket (2), plug (1) or locks (3, 4), replace corresponding component part.
Otherwise, the plug (1) of the ESP® control unit (N30/4) may work its way loose.

2	Push lock (4) and swivel bracket (2) approx. 90 ° upwards.

 The plug (1) thereby slides out of the jack on the ESP® control unit (N30/4).

 Do not use tools.

3	Pull plug (1) out of jack.

 While doing so, do not pull plug (1) out at bracket (2).
Otherwise damage will occur to the bracket (2).

4	Swivel bracket (2) downwards until the lock (4) latches into place.

 Otherwise the plug can become damaged.

Connect electrical connector

5	Swivel bracket (2) approx. 90 ° upwards.

6	Insert plug (1) into jack on ESP® control unit (N30/4) until it makes contact evenly along its entire length with the base of the jack.

 While doing so, do not pull plug (1) out at bracket (2).
Otherwise damage will occur to the bracket (2).

7	Swivel bracket (2) downwards until the lock (4) latches into place.

 The plug (1) thereby locks.

8	Slide gray lock (3) downwards.

Henviste dokumenter

ah0000z001901a Oplysninger om sikkerhedsrelevante komponenter
ah5400p000101a Oplysninger med henblik på at undgå skader på elektroniske komponenter på grund af elektrostatisk afladning