ar4240d9807ts

Remove/install left/right rear axle rpm sensor

Type ar · emne 42.40 · version 0100 · 2017-12-07

Gælder for: Model 907, 910

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 2 Chassis › 42 Bremsehydraulik og -mekanik › 42.40 Antispinregulering (ASR) — Serie 907 · Serie 910

EinPAS 26 Aktive sikkerhedssystemer › 26.20 Bremse-/traktionsregulering › 26.20.12 Sensor/kontakt/ledningssæt — Serie 907 · Serie 910

AR42.40-D-9807TS

Remove/install left/right rear axle rpm sensor

22.11.2017

Model

907, 910

Remove/install left/right rear axle rpm sensor

Shown on model 907 at left

1

Electrical connector

2

Screw

3

Sealing ring

4

Rpm sensor

5

Brake cover plate

D42.45-0055-06

Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

Remove/install

1

Raise vehicle

AR00.60-D-1000-04TS

Topical note

Special instructions for lifting and supporting vehicle

AH00.60-N-0100-01TS

2

Disconnect electrical connector (1)

Installation:
Spray electrical connector (1) and rpm sensor (4) with sealing wax.
This prevents any ingress of moisture and corrosion formation in the electrical connector (1) and the axle tube.

Installation:
Seal openings in brake cover plate (5).
Otherwise, sealing wax may enter the brake disk and brakepads.

Sealing wax

*BR00.45-Z-1020-05A

3

Remove screw/bolt (2)

Bolt, rpm sensor on rear axle

*BA42.30-N-1001-02TS

4

Remove rpm sensor (4)

Installation:
Insert rpm sensor (4) until it lies in the mounting hole. Do not tilt rpm sensor (4). The mounting flange of the rpm sensor (4) must lie fully on and flush with the axle tube.
Otherwise, the rpm sensor (4) may be damaged when tightening the bolt (2).

5

Remove sealing ring (3) from rpm sensor (4)

Installation:
Apply high-temperature antifriction bearing grease to new sealing ring (3).
This prevents any ingress of moisture and corrosion formation in the axle tube and the rpm sensor (4).

Installation: Replace sealing ring (3).

MB high-temperature antifriction bearing grease, 150 g

*BR00.45-Z-1016-06A

6

Install in the reverse order

7

Read out the fault memory

Connect/disconnect diagnostic unit

AD00.00-D-2000-06TS

Depending on findings

Erase the fault memory.

Rear axle rpm sensor

Number

Designation

Model 907

Model 910

BA42.30-N-1001-02TS

Bolt, rpm sensor on rear axle

Nm

8

8

Repair materials

Number

Designation

Order number

BR00.45-Z-1016-06A

MB high-temperature antifriction bearing grease, 150 g

A 001 989 23 51 10

BR00.45-Z-1020-05A

Sealing wax

A 000 989 38 58

Henviste dokumenter