S42.30-4531-09
Shown on model 470 on right side of vehicle |
1 | Electric line | 4 | Mounting clip | |
2 | Electrical connector | Pfeile | Bracket | |
3 | Electrical connector |
S42.30-4530-09
Shown on model 470 on right side of vehicle |
1 | Electric line | 7 | O-ring | |
5 | Bolts | Pfeile | Bracket | |
6 | Rpm sensor |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove | ||
1 | Switch off ignition and store transmitter key outside of transmission range (at least 2 m) | ||
2 | Raise vehicle | ||
Topical note | Special instructions for lifting and supporting vehicle | ||
3 | Unclip electric line (1) from holders (arrows) | ||
4 | Release and disconnect electrical connector (2) | ||
5 | Release electrical connector (3) and remove from retaining clip (4) | ||
6 | Unscrew screws (5) and remove rpm sensor (6) | ||
7 | Clean rpm sensor (6) | In case of recycling. | |
Assembly cleaner | |||
| Install | ||
8 | Check O-ring (7) for damage | If a problem arises | |
| |||
Replace rpm sensor (6). | |||
9 | Position rpm sensor (6) into opening on axle tube and tighten with screws (5) | Pay attention to installation position. | |
Screw/bolt, rear axle rpm sensor to rear axle | |||
10 | Slide electrical connector (3) onto retaining clip (4) from rear until it locks | ||
11 | Assemble electrical connector (2) until it locks | ||
12 | Clip electric line (1) into holder (arrows) | ||
13 | Read out and erase fault memory | ||
|
Henviste dokumenter
- ad0000s200006p
- ah0060n010001p Bemærkning til hævning og opklodsning
- ah5400p000101a Oplysninger med henblik på at undgå skader på elektroniske komponenter på grund af elektrostatisk afladning
- ar0060s100004p
- as0000z000201a Fare for personskade på hud og øjne ved håndtering af varme eller glødende genstande
- as0000z001001a Livsfare, hvis køretøjet glider ned fra eller tipper på liften.