ar4225w2000h

Remove/install electronic brake control (EBS) control unit

Type ar · emne 42.25 · version 0103 · 2019-07-16

Gælder for: Model 963 with code V2A (Actros model generation 1) except code V2B (Actros model generation 5) except code V2F (Actros S/M cab, model generation 5) Model 963 with code V2E (Antos model generation 1) except code V2B (Actros model generation 5) except code V2F (Actros S/M cab, model generation 5) Model 964 with code V2I (Arocs model generation 1) except code V2J (Arocs model generation 5) except code V3L (Actros BM964 model generation 5) Model 964 with code V3K (Actros BM964 model generation 1) except cod

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 2 Chassis › 42 Bremsehydraulik og -mekanik › 42.25 Elektro-pneumatisk bremse (EPB) — Serie 963 · Serie 964

EinPAS 21 bremser/vakuumsystem/trykluftsystem › 21.15 driftsbremse/vakuumsystem › 21.15.11 Styreenhed/relæ — Serie 963 · Serie 964

AR42.25-W-2000H

Remove/install electronic brake control (EBS) control unit

27.06.2019

Model

963

with code V2A (Actros model generation 1)

except code V2B (Actros model generation 5)

except code V2F (Actros S/M cab, model generation 5)

Model

963

with code V2E (Antos model generation 1)

except code V2B (Actros model generation 5)

except code V2F (Actros S/M cab, model generation 5)

Model

964

with code V2I (Arocs model generation 1)

except code V2J (Arocs model generation 5)

except code V3L (Actros BM964 model generation 5)

Model

964

with code V3K (Actros BM964 model generation 1)

except code V2J (Arocs model generation 5)

except code V3L (Actros BM964 model generation 5)

Remove/install electronic brake control (EBS) control unit

W42.25-1349-08

1

Lower paneling

A10b

Electronic Brake Control (EBS) control unit (Wabco)

A10c

Electronic Brake Control (EBS) control unit (Knorr)

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Remove/install

1

Connect diagnostic system, start XENTRY and perform quick test.

Only when replacing the electronic brake system control unit.

2.1

Select "Control unit replacement" and follow the instructions.

If the electronic brake system control unit is replaced.


Control unit replacement is completely menu-assisted under:
EBS - Electronic brake system (A10b, A10c) 
Adaptations 
Initial startup 
Control unit replacement

Installation: Follow "Control unit replacement" instructions.

2.2

Switch off ignition.

If the electronic brake system control unit is reused.

3

Remove lower trim (1).

AR68.10-W-1502H

4

Disconnect electrical connectors from electronic brake system control unit.

5

Remove electronic brake system control unit.

To do so, push electronic brake system control unit into rear holder and unhook upwards from front holder.

6

Install in the reverse order

Henviste dokumenter