W42.10-1153-01
1 Insert spacer (60 mm) between brake caliper (5) and threaded tube (3).
To avoid a complete undoing of the threaded tube (3).
2 Undo thrust piece by way of brake adjuster with adapter clockwise by max. 30 mm.
W42.10-0107-01
3 Use ejector fork (1) to pry off thrust piece (2) from threaded tube (3).
The flat side of the puller (1) must face the threaded pipe (3).
W42.10-0106-01
4 Apply screwdriver (4) to seat of bellows and drive-in by approx. 4 mm, in doing so do not damage the inner seal cap and seat.
In the event of damage to the inner seal cap the brake caliper will have to be replaced.
5 Pry out bellows.
6 Remove dry liner from cone of threaded tube.
If corrosion or water penetration is detected on thread of threaded tube, then the brake caliper must be replaced.