ar4210w020001b

Removing thrust piece with bellows

Type ar · emne 42.10 · version 0100 · 2016-05-12

Gælder for: Model 963 Disk brake ∅ 17.5", Knorr Model 967 Disk brake ∅ 17.5", Knorr'

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 2 Chassis › 42 Bremsehydraulik og -mekanik › 42.10 Driftsbremse — Serie 963 · Serie 967

EinPAS 21 bremser/vakuumsystem/trykluftsystem › 21.15 driftsbremse/vakuumsystem › 21.15.40 driftsbremse foran — Serie 963 · Serie 967

EinPAS 21 bremser/vakuumsystem/trykluftsystem › 21.15 driftsbremse/vakuumsystem › 21.15.42 driftsbremse bagest — Serie 963 · Serie 967

AR42.10-W-0200-01B

Removing thrust piece with bellows

Notes on tool combinations for repairs on the brake caliper

AH42.10-N-9406-11H

Model

963

Disk brake Ø 17.5", Knorr

Model

967

Disk brake Ø 17.5", Knorr

Removing thrust piece with bellows

1

Prepare tool combination (WK 1).


T15

Press-off fork

WK1

Tool combination

W42.10-1323-10

Removing thrust piece with bellows

2

Use ejector fork T5 (1) to pry off thrust piece (2) from threaded tube (3).


The flat side of the ejector fork T5 (1) must face the threaded pipe (3).


W42.10-0105-01

Removing thrust piece with bellows

3

Apply screwdriver (4) to seat of bellows and drive-in by approx. 4 mm, in doing so do not damage the inner dust cap and seat.


If the inner dust cap is damaged.

Replace brake calipers.



4

Pry out bellows.



5

Remove dry liner from cone of threaded tube (3).


If the thread of the threaded tube (3) is corroded or water ingress is found.

Replace brake calipers.


W42.10-0104-01

Henviste dokumenter