Front axle brake caliper
Number | Designation | Model 690.6 | Model 904 | Model 905 | ||
BA42.10-N-1002-10A | Bleed screw to brake caliper | M101 | Nm | 16 | 16 | 16 |
Rear axle brake caliper
Number | Designation | Model | Model | Model | |||
BA42.10-N-1003-12A | Bleed screw to brake caliper | M101 | Nm | 16 | 16 | 16 | |
D42.10-0081-05
1 First bleeder position right front
2 Second bleeder position left front
3 Third bleeder position right rear
4 Fourth bleeder position left rear
01 Bleeder unit
Shown on model 904
D42.10-0014-01
1 Fix ALB controller at full-load position.
The ALB controller must be secured with Panduit tape or wire in the full-load position due to pressure peaks which interfere with the bleeding procedure.
D42.10-0018-01
2 Connect bleeder unit to the reservoir and open shutoff cock (01).
D42.10-0017-01
A Bleed primary brake circuit
3 Start bleeding process at right front, then left front.
Fit bleeder hose onto the bleeder valve for this purpose and open bleeder valve.
In addition, depress brake pedal sharply every 23 seconds and allow to move back slowly.
The bleeding operation is completed once clear brake fluid free of bubbles flows out of the bleeder hose.
4 Close bleeder valve .
B Bleed secondary brake circuit
5 Start bleeding process at right rear, then left rear.
Fit bleeder hose onto the bleeder valve for this purpose and open bleeder valve. In addition depress the brake pedal sharply every 3‑4 seconds and allow to return slowly.
The bleeding operation is completed once clear brake fluid free of bubbles flows out of the bleeder hose.
6 Close bleeder valve .
D42.10-0016-01
7 Close shutoff valve and disconnect bleeding unit
8 Correct fluid level in brake fluid reservoir.
Fill quantity of brake fluid required, use brake fluid in accordance with Specifications for Operating Fluids, sheet 331.0.
9 Remove Panduit tape or wire at ALB controller.